MAINTENANCE 1. Remove the vent cap, open the drain valve and drain fuel into approved container, until level is below the collar. See Figure 25. 10. Start the engine and raise the rpm for one minute to purge the air. After the air is purged stop the engine, loosen the vent cap until the fuel level lowers to just above the collar. Tighten the vent cap by hand. Check for leaks. 2. Using a collar wrench remove collar and cover. 3. Remove the filter element from the separator head and discard filter and O-rings. Dispose of filter properly. Main Fuel Filter Element Changing 4. Clean the cover and the mounting surface on the body. Change the main fuel filter element as follows: 1.
Open the fuel tank fill cap to release pressure in the fuel system. Replace and tighten the cap. 5. Install the filter element with bottom grommet, new cover O-ring, cover and collar. Hand tighten only. 2. Clean the outside of the fuel filter housing (see Figure 26). 6. Fill cover half-way with clean fuel through the vent cap opening. 7. Replace O-ring on the vent cap and install in cover. Hand tighten only. NOTE: Do not use tools to tighten the collar or vent cap. 8. Tighten the drain plug. 9. Crank the engine for 30 seconds at a time, but no longer. Before cranking the engine again, wait at least two minutes. The engine should start within four, 30 second attempts.
Figure 26 Main Fuel Filter 76 All information subject to change without notice. (Rev. 04/08) DDC-SVC-MAN-0056 04/08 Copyright © 2008 DETROIT DIESEL CORPORATION