MAN — DDC-SVC-MAN-0056 - MBE4000 Safe Operation and Preventative Maintenance Manual

EPA04 MBE 4000 ENGINE OPERATOR'S GUIDE 3. Using a 36-mm socket, unscrew the cap on the main fuel filter housing. Remove the cap and lift the filter element a short distance within the filter housing allowing the fuel to drain off the filter. 9. Install a new O-ring on the filter cap and screw the cap onto the filter housing. Tighten the cap to 25 N·m (18 lb·ft). 10. If equipped with a hand pump on the fuel/water separator, work the hand pump until resistance is felt. 4. Remove the filter element from the cap and clean the filter cap. Discard the filter element and the O-ring from the cap. NOTE:

There should be a strong resistance in the hand pump, caused by the pressure build-up within the fuel system. NOTICE: To prevent damage to the filter housing, do not allow dirt to get into the filter housing. 11. Crank the engine for 30 seconds at a time, but no longer. Before cranking again, wait at least two minutes, then crank again. The engine should start within four 30-second attempts. 5. Clean the filter housing cap. 6. Replace the O-ring. 7. Lubricate the filter element rubber seal with a light coat of fuel oil and insert it into the filter housing. Push down and rotate the filter element while installing to ensure it is seated properly at the base of the housing. 12.

Once the engine starts allow it to idle for at least one minute or until idle is smooth before applying the throttle. Check the fuel filter housing for leaks. NOTE: A properly seated filter element will hold the fuel in the filter housing and prevent it from draining back to the tank. If the fuel does not stay in the housing the element is not seated properly, repeat steps 1 and 2. Engine Oil and Filter Changing Select the SAE class (viscosity) on the basis of the average air temperature for the season (see Figure 27). NOTE: Continued use of a single SAE class will result in frequent oil changes. For this reason, view the temperature ranges for the various SAE classes. 8.

Fill fuel filter housing with clean fuel oil. All information subject to change without notice. (Rev. 04/08) 77 DDC-SVC-MAN-0056 04/08 Copyright © 2008 DETROIT DIESEL CORPORATION