EPA04 MBE 4000 ENGINE OPERATOR'S GUIDE NOTICE: To prevent damage to the filter housing, ensure that no foreign objects get inside it. Do not wipe clean the filter housing. 5. Replace the O-ring on the cap (see Figure 30). 6. Install the new filter into the cap. Make sure the filter element is securely in place. Figure 29 Engine Oil Drain Plug, Oil Pan 7. Screw the cap onto the oil filter housing. Tighten the cap 45 N·m (33 lb·ft). [c] Discard the O-ring on the oil drain plug. 4. Remove both the filter cap and the filter element. To release the filter element, twist the lower edge of the filter element to the side (see Figure 30). 8. Install the oil drain plug, using a new O-ring.
Tighten the plug 80 N·m (60 lb·ft). To avoid injury from slipping and falling, immediately clean up any spilled liquids. PERSONAL INJURY 9. Add new engine oil through the oil fill (see Figure 31) until the maximum fill level on the oil dipstick has been reached. Engine fill capacity is 44 L (46 qts). Figure 30 Cap with Oil Filter Element All information subject to change without notice. (Rev. 04/08) 79 DDC-SVC-MAN-0056 04/08 Copyright © 2008 DETROIT DIESEL CORPORATION