MAINTENANCE 11. Check the filter and oil drain plug for signs of leakage. 12. Stop the engine. Check the oil level again after approximately five minutes. If necessary, add oil up to the maximum fill level on the oil dipstick. Figure 31 Oil Fill Optional Oil Centrifuge — Every 20,000 miles (32,000 km) change the oil centrifuge rotor as follows: 1. Remove the cover of the oil centrifuge. 2. Lift out the dirty rotor and replace it with a clean one (see Figure 32). To avoid injury when working near or on an operating engine, remove loose items of clothing, jewelry, tie back or contain long hair that could be caught in any moving part causing injury. 10.
Start the engine with the accelerator pedal in the idle position. Monitor the oil pressure gauge. NOTICE: Figure 32 Rotor Keep the engine running at idling speed until an oil pressure reading is obtained. If no oil pressure is shown after approximately 10 seconds, stop the engine and determine the cause. Failure to do so could result in engine damage. 3. Replace the centrifuge cover. 80 All information subject to change without notice. (Rev. 04/08) DDC-SVC-MAN-0056 04/08 Copyright © 2008 DETROIT DIESEL CORPORATION