MAN — DDC-SVC-MAN-0056 - MBE4000 Safe Operation and Preventative Maintenance Manual

MAINTENANCE NOTE: When topping off, use only a pre-prepared coolant mixture containing a 50 percent concentration by volume of corrosion-inhibiting antifreeze. Check the nitrite concentration at regular intervals as listed in Table 24 with a POWER Trac ® 3–Way Test Strip. Nitrite levels must be within 800–2400 PPM. Additional SCA must be added to the coolant when it becomes depleted, as indicated by a nitrite concentration of 800 PPM or less. If the nitrite concentration is greater than 800 PPM, do not add additional SCA. If the nitrite concentration is above 2400 PPM, the system is over-inhibited and should be partially drained and filled with a 50/50 mix of water and EG. NOTICE:

If the concentration of antifreeze is too low, there is a risk of corrosion or cavitation in the cooling system. 3. Check the coolant level and add more coolant if necessary. NOTE: Drain intervals listed in Table 24 are dependent on proper maintenance. Coolant Inhibitor Test Intervals Coolant inhibitor level should be checked at the intervals listed in Table 23. If topping off is needed, add coolant which is identical to the initial fill coolant. Table 23 Required Coolant Inhibitor Test Intervals 82 All information subject to change without notice. (Rev.

04/08) DDC-SVC-MAN-0056 04/08 Copyright © 2008 DETROIT DIESEL CORPORATION Service Application Inhibitor Test Interval On-highway Trucks and Motor Coaches 20,000 Miles (32,000 Kilometers City Transit Coaches, Pick-up and Delivery Short Trip, and Emergency Vehicles 6,000 Miles (9,600 Kilometers) or three months, whichever comes first Industrial, Continuous Duty Generator Set, and all Other Applications 500 Hours or three months, whichever comes first Standby Generator Set 200 Hours or yearly, whichever comes first