MAINTENANCE Inhibitor Level Checking Use Detroit Diesel POWER Trac Coolant Test Strips to measure nitrite and glycol concentrations. Cavitation/corrosion protection is indicated on the strip by the level of nitrite concentration. Freeze/boil-over protection is determined by glycol concentration. 3. Sixty seconds (one minute) after dipping, compare the nitrite pad to the color chart on the container to determine the nitrite concentration. 4. If the additive indicator (middle pad) shows any color change, this indicates the presence of an unauthorized inhibitor. Check the inhibitor level as follows: 5. If there is any doubt about the quality of the coolant, change the coolant. HOT COOLANT 6.
After each use, replace and tighten the cap on the test strip container. Discard any test strips that have turned light pink or tan in color. To avoid scalding from the expulsion of hot coolant, never remove the cooling system pressure cap while the engine is at operating temperature. Wear adequate protective clothing (face shield, rubber gloves, apron, and boots). Remove the cap slowly to relieve pressure. 7. Close and tighten the cap on the surge tank. 1. Dip the test strip into the coolant for one second, then remove it. Shake the strip vigorously to remove excess liquid. 2. Immediately compare the end pad to the color chart on the container to determine the glycol concentration.
84 All information subject to change without notice. (Rev. 04/08) DDC-SVC-MAN-0056 04/08 Copyright © 2008 DETROIT DIESEL CORPORATION