OPERATION EXPLANATION OF COMPONENTS The machine is equipped with an accumulator in the control cir- cuit. The accumulator in the control circuit is a device to store pressure. When this accumulator is installed, it is possible to operate the control circuit for a short time even after the engine is stopped. Therefore, it is possible to lower the work equipment under its own weight by operating the control lever in the direction to lower the work equipment. The accumulator is installed in the position shown in the dia- gram on the right. RELEASING PRESSURE IN CONTROL CIRCUIT ON MACHINE EQUIPPED WITH ACCUMULATOR 1.
Lower the work equipment to the ground, then close the crusher or other attachment. 2. Stop the engine. 3. Turn the key in the starting switch to the ON position again to let electric current flow in the circuits. 4. Set the safety lock lever to the FREE position, then operate the work equipment control levers and attach- ment control pedal (if equipped) backwards and forwards, and to the right and left to the full stroke to release the pressure in the control circuit. 5. Set the safety lock lever to the LOCK position to lock the control levers and attachment control pedal.
Note that the pressure is not completely removed, so when removing accumulator (1) in the control circuit and accumulator (2) in the valve return circuit, loosen the bolts slowly and do not stand where the oil can strike you if it spurts out. 125