MAINTENANCE INFORMATION MAINTENANCE HYDRAULIC HOSE INSTALLATION When removing parts at locations where there are O-rings or gasket seals, clean the mounting surface, and replace with new parts. When doing this, be careful not to forget to assemble the O-rings and gaskets. When installing the hoses, do not twist them or bend them into loops with a small radius. This will cause damage to the hose and markedly reduce its service life. CHECKS AFTER INSPECTION AND MAINTENANCE WORKS If you forget to carry out the checks after inspection and maintenance, unexpected problems may occur, and this may lead to serious injury or property damage. Do as follows.
Checks after operation (with engine stopped) Have any inspection and maintenance points been forgotten? Have all inspection and maintenance items been carried out correctly? Have any tools or parts been dropped inside the machine? It is particularly dangerous if parts are dropped inside machine and get caught in the lever linkage mechanism. Is there any leakage of water or oil? Have all the bolts been tightened? Checks when operating engine For details of the checks when operating the engine, see "TWO WORKERS FOR MAINTENANCE WHEN ENGINE IS RUNNING (PAGE 51)" and pay careful attention to safety. Are the inspection and maintenance items working properly?
Is there any leakage of oil when the engine speed is raised and load is applied to the oil pressure? SELECTING FUEL AND LUBRICANTS TO MATCH AMBIENT TEMPERATURE It is necessary to use fuel and lubricants that match the ambient temperature. For details, see USE OF FUEL, COOLANT AND LUBRICANTS ACCORDING TO AMBIENT TEMPERATURE217. 208