Komatsu — FUEL

MAINTENANCE LUBRICANTS, COOLANT AND FILTERS LUBRICANTS, COOLANT AND FILTERS HANDLING OIL, FUEL, COOLANT, AND PERFORMING OIL CLINIC OIL Oil is used in the engine and work equipment under extremely severe conditions (high temperature, high pres- sure), and it deteriorates with use. Use oil that matches the grade and temperature for use given in the Operation and Maintenance Manual. Even if the oil is not dirty, change the oil after the specified interval. Oil corresponds to blood in the human body, so be careful when handling it to prevent any impurities (water, metal particles, dirt, etc.) from getting in. The majority of problems with machine are caused by the entry of such impurities.

Take particular care not to let any impurities get in when storing or adding oil. Never mix oils of different grades or brands. Add the specified amount of oil. Having too much oil or too little oil are both causes of problems. If the oil in the work equipment is not clear, there is proba- bly water or air getting into the circuit. In such cases, please contact your Komatsu distributor. When changing the oil, replace the related filters. In partic- ular, when replacing the engine oil filter, fill the new filter with fresh, clean specified oil before installing. We recommend periodic analysis of the oil to check the condition of the machine.

For those who wish to use this service, please contact your Komatsu distributor. FUEL The fuel pump is a precision instrument, and if fuel contain- ing water or dirt is used, it cannot work properly. Be extremely careful not to let impurities get in when stor- ing or adding fuel. Use the fuel specified in the Operation and Maintenance Manual. Fuel may congeal depending on the temperature when it is used (particularly in low temperature below -15єC, so it is necessary to change to a fuel that matches the temperature. To prevent the moisture in the air from condensing and forming water inside the fuel tank, fill the fuel tank after completing the day's work. 209