LUBRICANTS, COOLANT AND FILTERS MAINTENANCE Before starting the engine, or when 10 minutes have passed after adding fuel, drain the sediment and water from the fuel tank. If the engine runs out of fuel, or if the filters have been replaced, it is necessary to bleed the air from the circuit. COOLING SYSTEM COOLANT River water contains large amounts of calcium and other impurities, so if it is used, scale will stick to the engine and radiator, and this will cause defective heat exchange and overheating. Do not use water that is not suitable for drinking. When using anti-freeze, observe the precautions given in the Operation and Maintenance Manual.
Komatsu machines are supplied with Komatsu specified anti-freeze in the coolant. This anti-freeze is effective in preventing corrosion of the cooling system. The anti-freeze can be used continuously for 2 years or 5000 hours. Therefore, it can be used as it is even in hot areas. Anti-freeze is flammable, so be extremely careful not to expose it to flame or fire. The ratio for the mixture of water and anti-freeze differs according to the ambient temperature. For details of the ratio, see "CLEAN INSIDE OF COOLING SYSTEM (PAGE 232)". If the engine overheats, wait for the engine to cool before adding coolant.
In addition to causing overheating, lack of cooling water also causes corrosion of the cooling circuit due to entry of air. GREASE Grease is used to prevent binding and noise at the joints. The nipples not included in the MAINTENANCE section are nipples used when overhauling, so they do not need to be greased periodically. If any part becomes stiff or generates noise after being used for a long time, grease it. Wipe off all of the old grease that is pushed out when greasing. Be particularly careful to wipe off the old grease in places where sand or dirt sticking in the grease would cause wear of the rotating parts. 210