Komatsu — INITIAL 250 HOURS MAINTENANCE (ONLY AFTER THE FIRST 250 HOURS)

MAINTENANCE MAINTENANCE PROCEDURE Mixing rate of water and antifreeze -30 16.0 16.0 Antifreeze is flammable, so keep it away from flame. Antifreeze is toxic. When removing the drain plug, be careful not to get water containing antifreeze on you. I If it gets in your eyes, flush your eyes with large quantities of fresh water and see a doctor at once. Use city water for the cooling water. If river water, well water or other such water supply must be used, contact your Komatsu distributor. We recommend use of an antifreeze density gauge to control the mixing proportions. Prepare a container to catch drained coolant: Min 32 liters capacity. Prepare a hose to supply water. 1.

Stop the engine and tighten corrosion resistor valve (1). (Only machines equipped with corrosion resistor) 2. Turn the radiator cap (2) slowly to release the internal pressure. 3. After doing this, push radiator cap (2) in and turn it slowly to remove it. 4. Remove the bottom cover, then set the container under drain valve (3) to catch the coolant mixture. Open drain valve (3) at the bottom of the radiator and drain the coolant. 9JH02642A 5. After draining the coolant, close drain valve (3), and fill with city water. When the radiator is full, start the engine and run at low idle to raise the temperature to at least 90°C, then continue to run for approx. 10 minutes. 6.

Stop the engine, open drain valve (2), and drain the water. 7. After draining the water, clean the radiator with detergent. For the cleaning method, follow the instruction of deter- gent. 8. Close drain valve (3). 9. Replace the corrosion resistor cartridge and open valves (1). 9JH02643A 233 Min. atmospheric temperature °C -10 -15 -20 -25 Amount of antifreeze liters 9.6 11.5 13.1 14. Amount of water liters 22.4 20.5 18.9 17. WARNING