Komatsu — INITIAL 250 HOURS MAINTENANCE (ONLY AFTER THE FIRST 250 HOURS)

MAINTENANCE MAINTENANCE PROCEDURE WASHING WASHABLE FLOOR When setting the machine at an angle, use strong blocks to stabilize the machine and be extremely careful when carrying out the operation. If the control levers are touched by mistake, the work equipment or machine may suddenly move, and this may lead to a serious accident. Set the safety lock lever securely to the LOCK position before standing up from the operator's seat. NOTICE When carrying out this operation, be careful not to get water on the monitor and connectors inside the operator's cab. Never spray water above the pedestal of the operator's seat (2).

With the washable floor, it is possible to flush out the dirt on the cab floor directly with water. Method of washing 1. Set the machine at an angle. 2. Swing the upper structure slowly so that water drain holes (3) in the cab floor are at a low position. 3. Lower the work equipment to the ground and set the machine in a stable position. 243 WARNING