Komatsu — INITIAL 250 HOURS MAINTENANCE (ONLY AFTER THE FIRST 250 HOURS)

MAINTENANCE MAINTENANCE PROCEDURE 2. If the electrolyte level is below the midway point between the U.L and L.L lines, remove cap (1) and add distilled water to the U.L line. 3. After adding distilled water, tighten cap (1) securely. REMARK If distilled water is added to above the U.L line, use a small hose or tubing to lower the level to the U.L line. Neutralize the removed fluid with baking soda (sodium bicarbonate), then flush it away with a large amount of water or consult your Komatsu distributor or battery maker.

When it is impossible to check electrolyte level from side of battery If it is impossible to check the electrolyte level from the side of the battery, or there is no display of the UPPER LEVEL line on the side of the battery, check as follows. 1. Remove cap (1) at the top of the battery, look through the water filler port, and check the electrolyte surface. If the electrolyte does not reach the sleeve, add distilled water so that the level reaches the bottom of the sleeve (UPPER LEVEL line) without fail. Use the diagram below for reference, and check if the electrolyte reaches the bottom of the sleeve.

(A) (B) (C) (D) 255 (A) Filler port (B) Sleeve UPPER Upper level LOWER Lower level (C) Correct level The electrolyte level is up to the bottom of the sleeve, so the surface tension causes the surface to rise and the plate appears to be warped. (D) Too low (level) The electrolyte level is not up to the bottom of the sleeve, so the plate appears to be normal.