Komatsu — INITIAL 1000 HOURS MAINTENANCE (ONLY AFTER THE FIRST 1000 HOURS)

MAINTENANCE PROCEDURE MAINTENANCE REMARK Use the feed pump to bleed air from the fuel system, when the machine has run out of fuel, too. CHECK SWING PINION GREASE LEVEL, ADD GREASE Prepare a scale. 1. Remove two bolts (1) on the top of the revolving frame and remove cover (2). 2. Insert a scale into the grease and check that the height of the grease in the portion where the pinion passes is at least 54 mm. Add more grease if necessary. 1 2 3. Check the color of the grease. If it is milky white, it is nec- essary to change the grease. Please contact your Komatsu distributor. 9JH02664A The total amount of grease : 33 liters 4. Install cover (2) with two bolts (1).

CLEAN AND INSPECT RADIATOR FINS, OIL COOLER FINS AND CONDENSER FINS If compressed air, high-pressure water, or steam hit your body directly, or they cause dirt or dust to be blown up, there is a danger of serious injury. Use safety glasses, dust mask, or other protective equip- ment. NOTICE When using compressed air, if the nozzle is brought too near the fins, the fins may be damaged. Use com- pressed air from a reasonable distance to prevent damage to the fins. Do not direct the jet directly at the core. If the fins are damaged, it will cause leakage of water and over- heating. On dusty jobsites, inspect fins every day, regardless of the maintenance interval. 1. Open engine hood (1). 2.

Loosen screw (3) and pull up net (2). 3. Clean net (2). (it is to be installed again, as instructed in the Step 8). 4. Loosen screw (5) and detach net (6) between the radiator and the oil cooler. 9JH092666A 262 WARNING