MAINTENANCE PROCEDURE MAINTENANCE CLEANING FRESH AIR FILTER 1. Pull up the lock release lever under the door release lever to release the lock. 2. Open cover (2) at the bottom left of the operator's cab by hand, pull out filter case (3) from the inside, then remove the filter. 3. Clean the filter with compressed air. If there is oil on the filter, or if the filter is extremely dirty, wash it in a neutral agent. After rinsing it in water, dry it thoroughly before using it again. If the clogging of the filter cannot be removed by blowing with air or washing in water, replace the filter with a new part. 4.
After cleaning, insert the filter in filter case (3) again, open the cover at the bottom left of the operator's cab by hand, return the filter case to its original position, then close the cover. When doing this, check that the lock is applied. REPLACE BREATHER ELEMENT IN HYDRAULIC TANK The parts and oil are still at high temperature after the engine is stopped, and may cause serious burns. Wait for the temperature to go down before cleaning the breather element in the hydraulic tank. When the oil filler cap is removed, oil may spurt out, so turn the cap slowly to release the internal pressure, then remove it carefully. 1.
Remove the cap from oil filler (F) at the top of the hydrau- lic tank. 9JH02669A 264 WARNING