Komatsu — INITIAL 1000 HOURS MAINTENANCE (ONLY AFTER THE FIRST 1000 HOURS)

MAINTENANCE MAINTENANCE PROCEDURE 10. To bleed the air, start the engine according to ""START- ING ENGINE (PAGE 139)" and run the engine at low idle for 10 minutes. 11. Stop the engine. CHANGE OIL IN SWING MACHINERY CASE The parts and oil are at high temperature after the engine is stopped, and may cause serious burns. Wait for the temperature to go down before starting the operation. Refill capacity: 6.6 liters 1. Remove cover (A) of the inspection hole. 2. Set an oil container under drain valve (P) under the machine body. 3. Loosen drain valve (P) and drain the oil. Then tighten the drain valve again. 4.

Remove the cap from oil filler (F) and add the specified amount of engine oil through oil filler (F). 5. Pull out dipstick (G) and wipe the off oil from it with a clean cloth. 9JH02672A 6. Insert dipstick (G) into the gauge pipe as far as it will go and then pull out it again. 7. If the oil level is between the H and L marks on dipstick (G), it is normal. If the oil does not reach the L mark, add more oil through oil filler (F). 8. If the oil level exceeds the H mark, drain the excess engine oil from drain valve (P), and check the oil level again. 9JH02674A When draining the excess engine oil, pull out hose (1) from the check hole (B) and then open the drain valve. 9JH02673A 267 WARNING