MAINTENANCE PROCEDURE MAINTENANCE CHECK OIL LEVEL IN DAMPER CASE, ADD OIL The parts and oil are at high temperature after the engine is stopped, and may cause serious burns. Wait for the temperature to go down before starting the work. NOTICE For the oil level check, park the machine on flat ground and wait for at least 30 minutes after the engine has stopped to start the work. 1. Open the cover on the right side of the machine. 2. Remove oil inspection plug (G) and check that the oil is near the bottom of the check hole.
If the oil level is low, remove the plug from oil filler (F), and add oil through oil filler (F) until the oil level is close to the bottom of the oil inspection plug (G) hole. NOTICE If the oil level is found to be high. Drain the oil to the spec- ified level. The excess oil may cause overheating. 3. Install oil inspection plug (G) and oil filler plug (F). 9JH02675A 4. Close the cover. CHECK ALL TIGHTENING PARTS OF TURBOCHARGER Contact your Komatsu distributor to have the tightening parts checked. CHECK PLAY OF TURBOCHARGER ROTOR Ask Komatsu distributor to check the play of the turbocharger rotor. REPLACE CORROSION RESISTOR CARTRIDGE (If equipped) 1.
Screw in valve (1) at the top the corrosion resistor. 2. Using a filter wrench, turn cartridge (2) to the left to remove it. 3. Coat the seal surface of the new filter cartridge with engine oil, then install it. When installing, bring the packing surface into contact with the seal surface of the filter holder, then tighten a fur- ther 2/3 turn. Always use a genuine Komatsu cartridge. 9JH02676A 4. Open valve (1). 5. Run the engine and check that there is no leakage of water from the seal surface. 268 WARNING