Komatsu — BASIC CHECK ITEMS

EXPLANATION OF COMPONENTS OPERATION TRAVEL SPEED MONITOR This monitor (6) displays the set mode for the travel speed. When the travel speed selector switch is operated the monitor displays one of the following selections. Lo : Low speed Mi : Medium speed Hi : High speed POWER MAX MONITOR This monitor (7) shows if the power max function is being actu- ated. The monitor display (when the knob switch on the left control lever is operated) is as follows. Monitor lights up: Digging power is increased while knob switch is kept pressed. REMARK The digging power is increased while the knob switch is being pressed only for working modes A and E.

Note that even if the knob switch is kept pressed, the increase in power ends after 8.5 seconds. Monitor goes out : Power max function stopped METERS ENGINE WATER TEMPERATURE GAUGE This meter (8) indicates the engine cooling water temperature. During normal operations, the indicator should be in the black range. If the indicator enters the red range during operations, the overheat prevention system is actuated. The overheat prevention system acts as follows. Red range position (A) : Engine water temperature monitor (1) lights up red Red range position (B) :

Engine speed is reduced to low idle, engine water temperature monitor lamp (C) lights up red, and the alarm buzzer sounds at the same time. Red range Black range The overheat prevention system remains actuated until the indicator returns to the black range. When the engine is started, if the indicator is at position (C), engine water temperature monitor (1) lights up white. In this case, carry out the warming-up operation. For details, see "WARMING-UP OPERATION (PAGE 144)". 74