Isuzu — Isuzu N Series Training Manual

Reassembly 1. Pump Cover 2. Oil Relief Valve 3. Oil Relief Valve Spring 4. Sprig Seat 5. Cotter Pin N6A0172E N6A0174E 2. Use an inside dial indicator or inside micrometer to measure the pump cover bushing inside diameter and the cylinder body inside diameter. If clearance between the gear shaft and the bush- ing exceeds the specified limit, the oil pump as- sembly must be replaced. 6. Driven Gear and Shaft Apply the engine oil to the driven gear shaft. N6A0175E 7. Oil Pump Assembly 1) Carefully wipe any foreign material from cylin- der body rear surface. 2) Apply the recommended liquid gasket (Three Bond 1141E) or its equivalent to the shaded ar- eas shown in the illustration. Caution:

Be careful that no liquid gasket gets into the holes in the arrow-marked portion in the illustration and the inside of the oil pump cover. N6A0173E Gear Shaft Outside mm (in) Diameter Standard Limit 15.989 —16.000 (0.6295 — 0.6299) 15.9 (0.626) Gear Shaft and Bushing mm (in) Clearance Standard Limit 0.04 — 0.07 (0.0016 — 0.0028) 0.2 (0.012)