Isuzu — Isuzu N Series Training Manual

PROBLEM POSSIBLE CAUSE CORRECTION Pulls to One Side (Cont.) 6. Wheel cylinder sticking. 7. Weak or broken shoe return spring. 8. Out-of-round drums or different sized drums on the same axle. 9. Brake dragging. 10. Weak chassis springs, loose U-bolts, loose steering gear, etc. 11. Loose steering. 12. Unequal camber. 13. Restricted brake line or hose. 14. Wheel cylinder size different on oppo- site sides. 15. Loose kingpin. 16. Distorted, damaged, or scored drum/ disc. 17. Front end alignment. 18. Excessively worn lining/pad. 19. Uneven adjustment of brake lining clearance. 20. Water/wet linings. 6. Repair or replace the wheel cylinder. 7.

Check the spring-replace distorted, open coiled, or cracked spring. 8. Refinish or replace the drums in axle pairs. 9. Check for loose lining. Adjust. (Refer to “Dragging Brakes”.) 10. Replace the spring, tighten the U-bolts, adjust the steering gear, etc. 11. Repair and adjust. 12. Adjust to specifications. 13. Check for soft hose or damaged lines. Replace as necessary. 14. Replace with correct cylinders. 15. Replace the kingpins or bushing. 16. Refinish the drums/discs in axle pairs. Replace if necessary. 17. AIign the front end. 18. Replace in axle sets. 19. Adjust the brake lining clearance in all wheels. 20. Apply the brakes a few times while moving at a slow speed to dry the lin- ings.

One Wheel Locks 1. Gummy lining/pad. 2. Tire tread slick. 3. Brake adjustment not correct. 4. Restricted brake line or hoses. 5. Incorrect lings/pads. 6. Grease or fluid soaked lining/pads. 7. Foreign material in the brakes. 1. Replace in axle sets. 2. Match up tire treads from side to side. 3. Adjust the brakes. 4. Check for soft hoses or damaged lines. Replace as necessary. 5. Replace. Linings/pads must be the same on the axle. 6. Replace in axle sets. 7. Remove the material. Light Pedal Pressure Brakes too Severe (Grabby Brakes) 1. Brake adjustment not correct. 2. Loose mounting plate on the front axle. 3. A small amount of grease or fluid on the lining/pad. 4. Incorrect lining/pad. 5.

Wheel bearings loose. 6. Lining loose on the shoe. 7. Excessive dust and dirt in the drum. 8. Out-of-round drum. 1. Adjust the brakes. 2. Tighten the plates. 3. Replace the linings/pads. 4. Install factory specified linings/pads. 5. Adjust the wheel bearings. 6. Replace the lining or the shoe and lin- ing. 7. Clean and sand the drums and linings. 8. Turn the drums in pairs or replace.