PROBLEM POSSIBLE CAUSE CORRECTION Low Pedal or Pedal Goes to Floor 1. Excessive clearance between the lin- ings and drum. 2. Pedal stop not adjusted, or missing. 3. Weak brake hose. 4. Leaking wheel cylinder. 5. Air in the hydraulic system. 6. Improper brake fluid (low boiling point). 7. Low fluid level. 8. Bent or distorted brake shoes. 9. Leaks at hydraulic line connections. 1. Adjust the brakes. 2. Adjust or install the pedal stop. 3. Replace with new hose. 4. Clean and rebuild. 5. Bleed the hydraulic system. 6. Flush the system and refill with recom- mended brake fluid. 7. Fill the reservoir with brake fluid; check for leaks and bleed system. 8. Replace in axle sets. 9.
Check for hydraulic leaks and repair. Slow Brake Release 1. Foot pedal binding. 2. Restriction in the line. 3. Weak shoe return spring. 1. Lubricate the pivot pin; clean-check for foreign objects. 2. Remove the restriction or replace line. 3. Replace the spring. Poor Assist or Loss of Assit 1. Low brake fluid level. 2. Air in the hydraulic system. 3. Weak brake hose. 4. Loss of vacuum. 5. No brake fluid at the master cylinder. 1. Fill the reservoir to the proper level. Bleed the system. 2. Locate the source of the air leak and re- pair. Bleed the system. 3. Replace. 4. Inspect for vacuum leaks or malfunc- tioning pump. Repair or replace as nec- essary. 5.
Check for plugged, kinked, or damaged hose to the reservoir. Brake Fade 1. Incorrect lining/pad. 2. Poor lining/pad contact. 3. Thin drum. 4. Dragging brakes. 5. All conditions listed under “Pulls to One Side”. 1. Replace with recommended lining/pad. 2. Grind the lining/pad to the proper radi- us; adjust. 3. Replace the drum. 4. Adjust. 5. All corrections listed under “Pulls to One Side”. All Brakes Drag when Adjustment is Known to be Correct 1. Pedal does not return to stop. 2. Improper fluid. 3. Use of incorrect rubber parts. 1. Lubricate the pedal linkage; adjust the pedal. 2. Replace rubber parts and fill with the recommended brake fluid. 3. Install the proper parts.