PROBLEM POSSIBLE CAUSE CORRECTION One Wheel Drags 1. Weak or broken shoe return spring. 2. Brake shoe to drum clearance too small. 3. Loose wheel bearings. 4. Wheel cylinder piston cups swollen and distorted or piston stuck. 5. Pistons sticking in the wheel cylinder. 6. Drum out-of-round. 7. Disc warped. 8. Restricted brake line or hose. 9. Distorted shoe. 10. Defective lining/pad. 11. Loose or bent mounting plate. 12. Loose calipers. 1. Replace the return spring. 2. Adjust to specification. 3. Adjust or replace the wheel bearings. 4. Rebuild the cylinders. Flush the hydrau- lic system and fill with recommended fluid. 5. Clean or replace the pistons; clean the cylinder bore. 6.
Machine the drum. 7. Machine the disc. 8. Check for soft hoses or damaged lines. Replace as necessary. 9. Replace. 10. Replace with the recommended lining/ pad. 11. Tighten the fasteners; replace the plate. 12. Tighten the fasteners. Dragging Brakes 1. Improper fluid. 2. Brake pedal adjustment incorrect. 3. Incorrect shoe return spring. 4. Brake pedal linkage interference or binding. 5. Incorrect lining/pad. 6. All conditions listed under “One Wheel Drags”. 1. Flush the hydraulic system and fill with recommended brake fluid, and replace rubber components. 2. Adjust the pedal. 3. Replace the shoe return spring. 4. Free the linkage and lubricate. 5. Replace the linings/pads. 6.
All corrections under “One Wheel Drags”.