PROBLEM POSSIBLE CAUSE CORRECTION Bad brake operation (lack of smoothness in operation) 1. Poor operation of the booster • Input-output rod circumference sticks • Bad spool valve operation • With the engine on, repeatedly press the brake pedal and confirm the pedal operation state. • If there is sticking or some other abnor- mality in the pedal operation, replace the hydro boost assembly as neces- sary. Abnormal brake noise (when pressing the pedal) 1. Air in the hydraulic booster lines • With the engine running, check the amount of hydraulic fluid remaining in the reserve tank for the hydraulic boost- er.
• If low, add fluid (Besco ATF III) and bleed to remove air as necessary be- fore starting the engine. Operate the pump and repeatedly step on the pedal to confirm the gear noise (caused by cavitation). 2. Water in the hydraulic fluid • Check the color of the hydraulic fluid in the reserve tank for the hydraulic boost- er (normal: purple, abnormal: milky white). • If the hydraulic fluid is milky white, change the fluid (Besco ATF III) and bleed to remove air as necessary be- fore starting the engine. Operate the pump and strongly press the pedal until reaching full boost range to confirm the gear noise (caused by cavitation).
The length of time to keep the pedal pressed all the way down is no more than five seconds. No pedal boosting effect immediately after turning the engine off 1. Faulty charge valve • Gas leaking from the accumulator • Leakage inside the charge valve • Keep the engine running for more than 10 seconds. Turn off the engine, and within 60 seconds, step on the pedal once to confirm boosting effect. Boosting effect means the same pedal effort if the engine was running. • If boosting effect does not exist, either the hydraulic booster assembly or the accumulator may need to be replaced.