Brake Lining PROBLEM POSSIBLE CAUSE CORRECTION Poor Contact at the Center of Shoe 1. Bell-mouthed drum. 2. Distorted mounting plate. 3. Bent brake shoe. 4. Undersize linings. 5. Loose wheel bearing. 1-5. Repair or replace as required. Unequal Wear on the Shoes in the Same Brake 1. Brake linings not a balanced set. 2. Sticking wheel cylinder piston. 1-2. Repair or replace as required. Material at the Center of the Shoe Exces- sively Thin 1. Undersize linings. 2. Oversize drum. 1-2. Repair or replace as required. Lining Tapered across the Width 1. Bell-mouthed drum. 2. Bent shoe. 3. Distorted mounting plate. 1-3. Repair or replace as required. Lining Worn at One End Bent mounting plate.
Repair or replace as required. Linings Glazed 1. Grease on lining. 2. Wrong type lining for service involved. 1-2. Repair or replace as required. Rivets Tear Loose 1. Improper set rivet. 2. Improper setting of the rivet. 3. Enlarged rivet holes in the shoe. 1-3. Repair or replace as required. Unequal Wear Opposite Brakes, Same Axle 1. Weak shoe return spring. 2. Obstructed hydraulic line. 3. Stuck wheel cylinder piston. 4. Brake drum surface in poor condition. 5. Loose wheel bearing. 1-5. Repair or replace as required. Linings at Scored 1. Scored drum. 2. Abrasive material between the lining and drum. 1-2. Repair or replace as required. Cracks at Rivet Holes 1. Wrong type rivets. 2.
Rivets not properly set. 3. Dirt or rust on the shoe table. 4. Wrong size lining. 1-4. Repair or replace as required. Elongation of the Rivet Holes 1. Loose rivets. 2. Wrong size rivets. 1-2. Repair or replace as required. Wear on the Edge of the Lining 1. Wrong width lining. 2. Holes improperly drilled. 3. Loose wheel bearing. 4. Bent shoe. 1-4. Repair or replace as required. Groove on the Edge of the Lining 1. Lining too wide. 2. Worn drum. 1-2. Repair or replace as required.