Remove the transmission nuts and bolts from the flywheel housing. Remove the transmission by pulling it toward the rear of the vehicle while slowly lowering the transmission jack. Engine Left Side 1. Intake Air Duct 2. Heater Hose 3. Vacuum Hose 4. Engine Stop Cable Loosen locking nut at bracket and disconnect en- gine stop cable from injection pump stop lever. 5. Accelerator Control Cable Loosen locking nut at bracket and disconnect ac- celerator control cable from injection pump control lever. 6. Fuel Return Hose 7. Fuel Feed Hose Disconnect fuel hose from injection pump side and take care not to spill and enter dust. N6A0751E 7. Shift Cable 8. Select Cable 9.
Clutch Slave Cylinder 1) Disconnect the clutch return spring from the clutch slave cylinder. 2) Remove the slave cylinder from the clutch shift fork. Engine Front Side 1. Radiator Upper Hose 2. Coolant Reserve Tank Hose/Bypass Hose 3. Radiator Lower Hose 4. Fan Guide 5. Radiator 6. Fan Engine Right Side 1. Front Exhaust Pipe 2. Power Steering Pump Remove the power steering pump from the engine side with the bracket attached, and fasten it with a wire to the appropriate location, together with the hoses. 3. Air Conditioning (A/C) Compressor (If equipped with A/C) 1) Remove the A/C compressor drive belt.
2) Dismount the compressor from the A/C com- pressor bracket, and fasten it with a wire to the appropriate location, together with the hoses. 4. ACG Vacuum Hose Disconnect the vacuum hoses from vacuum pump side. 5. ACG Harness Disconnect the B terminal cable and harness con- nector from generator. N6A0752E 10. Starter Earth Cable 11. Starter 1) Disconnect the battery cable at the starter mo- tor. 2) Remove the starter assembly from flywheel housing. 12. Transmission Mounting Nut 1) Check that the engine lifting is securely sup- porting the engine. 2) Remove the engine rear mounting bracket nuts from the No.3 crossmember. 13. Transmission Assembly Engine Mounting Side 1.
Engine Mount Attach lifting wires to the engine lifting hangers and slightly raise the engine. Remove the engine mounting rubber nuts attach- ing the engine mounting crossmembers.