Isuzu — Isuzu N Series Training Manual

3. Wait 15 seconds to let battery recover. Then apply specified load from specifications (See Main Data and Specifications in this section). Read voltage after 15 seconds, then remove load. 1) VOLTAGE DOES NOT DROP BELOW THE MINIMUM LISTED IN FOLLOWING TABLE - The battery is good and should be returned to service. 2) VOLTAGE IS LESS THAN MINIMUM LISTED -Replace battery. Jump Starting Jump Starting With An Auxiliary (Booster) Battery Caution: Never push or to the vehicle in an attempt to start it. Serious damage to the emission system as well as other vehicle parts will result. Treat both the discharged battery and the booster bat- tery with great care when using jumper cables.

Carefully follow the jump starting procedure, being care- ful at all times to avoid sparking. FAILURE TO CAREFULLY FOLLOW THE JUMP STARTING PROCEDURE COULD RESULT IN THE FOLLOWING: 1. SERIOUS PERSONAL INJURY, PARTICULAR- LY TO YOUR EYES. 2. PROPERTY DAMAGE FROM A BATTERY EX- PLOSION, BATTERY ACID, OR AN ELECTRI- CAL FIRE. 3. DAMAGE TO THE ELECTRONIC COMPO- NENTS OF ONE OR BOTH VEHICLES PARTIC- ULARLY. Never expose the battery to an open flame or electrical spark. Gas generated by the battery may catch fire or explode. Remove any rings, watches, or other jewelry before working around the battery. Protect your eyes by wear- ing an approved set of goggles.

Never allow battery fluid to come in contact with your eyes or skin. Never allow battery fluid to come in contact with fabrics or painted surfaces. Battery fluid is a highly corrosive acid. Should battery fluid come in contact with your eyes, skin, fabric, or a painted surface, immediately and thor- oughly rinse the affected area with clean tap water. Never allow metal tools or jumper cables to come in con- tact with the positive battery terminal, or any other metal surface of the vehicle. This will protect against a short circuit. Always keep batteries out of the reach of young chil- dren. Jump Starting Procedure 1. Set the vehicle parking brake.

If the vehicle is equipped with an automatic trans- mission, place the selector lever in the “PARK” po- sition. If the vehicle is equipped with a manual transmis- sion, place the shift lever in the “NEUTRAL” posi- tion. Turn “OFF” the ignition. Turn “OFF” all lights and any other accessory re- quiring electrical power. 2. Look at the built-in hydrometer. If the indication area of the built-in hydrometer is completely clear, do not try to jump start. On-vehicle Service Battery Charging Observe the following safety precautions when charging the battery: 1. Never attempt to charge the battery when the fluid level is below the lower level line on the side of the battery.

In this case, the battery must be replaced. 2. Pay close attention to the battery during the charg- ing procedure. Battery charging should be discontinued or the rate of charge reduced if the battery feels hot to the touch. Battery charging should be discontinued or the rate of charge reduced if the battery begins to gas or spew electrolyte from the vent holes. 3. In order to more easily view the hydrometer blue dot or ring, it may be necessary to jiggle or tilt the battery. 4. Battery temperature can have a great effect on bat- tery charging capacity. 5. The sealed battery used on this vehicle may be ei- ther quick-charged or slow-charged in the same manner as other batteries.

Whichever method you decide to use, be sure that you completely charge the battery. Never partially charge the battery. ESTIMATED TEMPERA- TURE MINIMUM VOLTAGE °F °C 70 21 9.6 60 16 9.5 50 10 9.4 40 4 9.3 30 −1 9.1 20 −7 8.9 10 −12 8.7 0 −18 8.5 The battery temperature must be estimated by feel and by the temperature the battery has been exposed to for the preceding few hours. WWaArRnNinINg:G: