2. Inspection and Adjustment 2.4 Sensor Inspection 2.4.1 Oil pressure switch Disconnect the connector from the oil pressure switch. Keep the voltammeter probes in contact with the switch terminal and cylinder block while operating the engine. It is abnormal if circuit is closed. 2.4.2 Thermo switch Place the thermo switch in a container filled with antifreeze or oil. Heat it while measuring the fluid temperature. The switch is normal if the voltammeter shows continuity when the fluid temperature is 107 113 deg C. 2.5 Water leak check in cooling water system Check coolant water leakage from the cooling water system visually. If any problem is found, Inspect as follows.
1) Fill coolant water to the normal level in the radiator, and install the cap tester on the radiator. 2) Operate the manual pump to set the pressure to 0.09 0.15kgf/cm 2 ). If the cap tester pressure gage reading drops then, water is leaking from the cooling water system. Check the water leaking point. 0.015MPa (0.9 50