Yanmar — Yanmar Electronic Control System Technical Manual for Classic, BY2, 6LY3, 6CX, and SY GEN III Series Engines

4 Gauges 6LY3, 6CX, SY GEN III, alternate BY2 Unlimited Speed The two common types of speed encountered are Speed Over Water (SOW) and Speed Over Ground (SOG). Speed over water typically uses a paddle wheel as the sensor while speed over ground uses a GPS. Speed over water is affected by current, the placement of the paddle wheel and the buildup of growth on the paddle wheel. Speed over ground is not affected by any of these items and is considered more accurate. That said, remember that SOG is based on straight lines so if making many turns it will experience short term errors.

The typical update rate on SOG from a GPS is in the order of one second so it can have a slower response than the paddle wheel. When SOG is available most users prefer to use it as their speed indication. The i2200 series of gauges looks for both types of speed. If it finds SOG that is the parameter it will display. If no SOG is available on the CAN Bus it will revert to speed over water (SOW) and look for that input on the CAN Bus. Power A complete set of gauges draws just under one amp from the CAN Bus. The three inch gauges draw 200 mAMPs each and two inch gauge draws 125 mAMPs each. It is important to assure the CAN Bus has an adequate power supply to handle all the attached items.

This is especially true when units with up to one amp draw, like gauges, are located far from the CAN Bus power source. For a complete discussion of CAN Bus power requirements see “Section 8 - Networks” of this manual. Transmitted Parameters The 6LY3, 6CX, SY GEN III and BY2 Unlimited transmit the following engine parameters that have i2200 gauge implications. For a complete list of all data transmitted by the engine see “Section 8 - Networks” of this manual.

Oil Pressure Coolant Water Temperature Turbo Boost Pressure Voltage Trim if present Fuel level if senders connected 6LY3, 6CX and SY GEN III transmit LOAD SY GEN III transmits TORQUE Note - Port engine interface sends port fuel level if sender connected; Starboard engine interface sends starboard fuel level if sender connected; Center engine interface sends center fuel level if sender connected. NMEA Instance 2; Yanmar Aux 2 © 2011 Yanmar Marine International • Rev. 2.0 Yanmar Electronic Control Systems Technical Manual 4:27