8 Networks When multiple power sources are used to power the CAN Bus, diodes which stop the CAN Bus from becoming a commoning path are required. Products that require more than one amp must draw their power from another source. The CAN Port that connects this type of device to the CAN Bus must be isolated from the unit’s main power source. This is normally accomplished with optical isolators. This protects the network from a local failure and prevents ground loops. The circuits that are in these units on the CAN Bus side of the isolators receive their power from the CAN Bus. Thus all items on the CAN Bus use some amount of power from the CAN Bus.
The CAN Bus cable has a modest wire gauge (22AWG) to handle power. As items are added to the CAN Bus and as the CAN Bus cable length increases resistance losses in the cable can cause a unit to drop below its rated voltage and shutdown. To protect against this failure it is necessary to take into account both the length of the cable and the number and type of devices on the cable. When the distance is too long for the connected equipment an additional power feed needs to be added along the cable. On the following pages are some general guidelines with the distance from the CAN Bus power source to the helm. This is the X distance in the diagram above. © 2011 Yanmar Marine International • Rev.
2.0 Yanmar Electronic Control Systems Technical Manual 8:11