Yanmar — Yanmar Electronic Control System Technical Manual for Classic, BY2, 6LY3, 6CX, and SY GEN III Series Engines

8 Networks Understanding - Auto addressing is a powerful feature of the NMEA 2000 ® CAN Bus protocol as it means no network setup is ever required. You may add and remove devices at any time so long as the network backbone connections and terminators are left intact. Errors While the NMEA 2000 ® CAN Bus is operating occasionally a specific data transmission will fail. There are a number of reasons for a message to fail and an example would be two messages arrive at exactly the same time. “Retrys” then occur and data usually goes through. On a properly operating network the protocol handles these failures and recovers operation without any detrimental effect.

In test conditions it is common to have the system operating properly with upward of fifty errors per second occurring. While the protocol is robust and handles this type of situation it is an indication there is an issue on the CAN Bus that should be resolved. On a typical system it is also likely a few errors will occur, particularly on start up while auto addressing is sorting out the network. An occasional error will occur on a perfect system as timing probability alone will cause an occasional message failure. The rate of these failures is dependent on the number and type of devices on the bus.

As a general rule 0-10 errors on start up is common and less than 2 errors per second is common on a properly working bus. Understanding - Because the NMEA 2000 ® protocol is so robust it can cover up a modest problem on the network. After a system is installed a check of the CAN Bus should be made to assure proper operation. See i5601E test features below. Priority The NMEA 2000 ® protocol defines eight priority levels. These are assigned by product type. The protocol dictates that messages with the highest priority are handled before lower priority messages. This assures that mission critical messages get through.

There is no noticeable delay of any critical signal, like shifting, even on a network with very heavy traffic. Some networks like Ethernet treat all the messages the same. When a collision occurs both units retry at a later time. Thus, a mission critical message might be put off. The term for this type of protocol is non-deterministic, which means you are not sure when a specific message will get through. NMEA 2000 ® is a deterministic protocol. The various features like priority handling and retries etc. assure the critical message will be delivered in a given timeframe. © 2011 Yanmar Marine International • Rev. 2.0 Yanmar Electronic Control Systems Technical Manual 8:15