8 Networks Bus Traffic The NMEA 2000 ® protocol is intended to handle mid-size communication tasks. These include but are not limited to the following types of information. Engine data; tachometer, oil pressure, volts, temperature, etc. Alarms Speed Position Depth Control signals; shift and throttle. GPS data Autopilot data Tank levels Steering Information The protocol is not intended to handle large amounts of high speed data. Thus detail sonar pictures, radar images, and television type pictures are not handled on the NMEA 2000 ® CAN Bus. A properly operating NMEA 2000 ® system can easily handle up to the fifty devices the standard specifies.
In an actual on-boat system with up to twenty five devices from multiple manufacturers a typical network traffic level is in the low 20 % range. A basic engine package like those supplied with the Yanmar electronic engines typically operates in the 10% range. Understanding - A typical NMEA 2000 ® CAN Bus network should operate in the 1 to 25% bus load range. Readings above 25% for any length of time indicate a problem that should be addressed. Test Screens The i5601E, with software revision 3.0 or higher , has several screens to help technicians diagnose errors on the NMEA 2000 ® Data Bus. This feature works with NMEA 2000 ® equipment from all suppliers.
The amount of data available for each item depend on what the software of a manufacturer has installed for a device. Network Status Display The Network Status Display Screen shows details of the NMEA 2000 ® Network and allow determination of Network Problems. (The values are constantly monitored and do not rely on the screen being displayed.) Bus Load: Current bus load over 1 sec Peak Load: Peak Load since last Reset or “Power On” Frames/Sec: Current frames transferred over 1 sec Total Frames: Total number of frames since last Reset or “Power On” Error Frames/Sec: Error frames over 1 sec Errors Total:
Total Number of errors received since last Reset or “Power On” Bus Off If YES, indicates unit is not Transmitting on Bus Bus Voltage: Measured Value of Bus Supply Buttons: “Reset” - Resets the various parameters that have accumulated values “Back” - Moves back to previous menu © 2011 Yanmar Marine International • Rev. 2.0 8:16 Yanmar Electronic Control Systems Technical Manual