11 by2 Series Engines - Yanmar zt350 Stern Drive Shift Cable Connections 1. Install the Shift Bracket per the Stern Drive’s installation instructions. 2. Install the Shift Cable to the Shift Bracket in “Neutral” position. 3. Set the Shift into Neutral. 4. Turn on the power to the actuator, this will set the actuator to “Neutral.” Then turn off the power. 5. Connect the shift cable to the actuator: Note: Make sure that the ends of Shift Cable are set in their respective detents with room to adjust the barrel/adjustment nuts. a. Remove the cover plate (4 screws) as shown below. b.
Position the end of the cable above the cable mount so the notch on the cable will fit into the detent in the mount. c. Place the rubber Grommet around the shaft of the cable, just in front of the two hex crimps. This will slide into the side edges of the housing. d. Screw the Brass Adjustment Barrel approximately halfway onto the end of the cable. Adjust the barrel and cable so it will fit into the slot toward the top of the cable mount. Once the proper position is found, screw on the Jam Nut (supplied with the cable) and tighten against the Adjustment Barrel. e. Secure the Brass Adjustment Barrel to the cable mount with the Steel Retainer. f.
Fit the cable into the cable mount so that all previous components are seated into their respective spots. g. Replace the cover. a. a. a. a. d. e. c. d. b. f. d. © 2011 Yanmar Marine International • Rev. 2.0 Yanmar Electronic Control Systems Technical Manual 11:9