11 by2 Series Engines - Yanmar zt350 Stern Drive CAN Bus Connections The NMEA 2000 ® connector of the CE50206 cable connects to the Actuator as shown below. NMEA Connector If you need to connect a new system, follow these steps: 1. Locate the NMEA 2000 ® connector of the CE50206 cable and remove the CM10055 terminator, if one is there. Install a CM10703 cable into the NMEA 2000 ® connector and put a CM10060 “T” connector at the end of the CM10703 cable. 2. Put a CM10052 terminator at the end of the “T” connector. 3. Plug the Actuator cable NMEA 2000 ® connector into the node of the “T.” 4. The CM10703 cable can be extended using a CM100XX CAN Bus cable, if required.
© 2011 Yanmar Marine International • Rev. 2.0 11:10 Yanmar Electronic Control Systems Technical Manual