Yanmar — Yanmar Electronic Control System Technical Manual for Classic, BY2, 6LY3, 6CX, and SY GEN III Series Engines

15 Troubleshooting introduction This section covers troubleshooting the electronic control system and the CAN Bus. It is assumed that the initial installation was performed correctly and the system was operating for a period of time before the fault occurred. While it is possible that this information may help with an installation problem, typically the type of problems encountered on a new installation are outside the scope of this section. The best solution for a problem with a new installation is to review all the steps in the specific engine installation manual. This section’s purpose is to identify, not repair, the failed component(s).

The internal parts of the electronic modules are not suitable for field repair. A failed module must be replaced. The same is true of a failed NMEA 2000 ® cable or connector. Failed and/or defective CAN Bus cables and connectors are not suitable for field repair and should be replaced. This section is divided into: 1. General Approach 2. Initial Review 3. CAN Bus Check and Diagnostics 4. Power 5. Individual Component Problems 6. Connector Problems 7. Power Reduction Modes 8. Helpful Hints 9. Diagnostic Trouble Codes Note: Any troubleshooting problems regarding the engine itself should be addressed in the appropriate engine manual.

The i5601E Digital Display will provide diagnostic messages about the engine but the information and explanation of those messages will only be covered in the engine manual. See “Section 3 - i5601E Digital Display” in this manual for operation of the i5601E unit and its message displays. General Approach The Yanmar Electronic Control System has a number of built-in features to aid in locating a problem. The recommended first step in troubleshooting any system problem is to use these features and indicators to determine a starting point for a more detailed check. In performing this initial review you are trying to determine which broad area is causing the problem.

The likely possibilities are: Power or Data problem within the Control System. Individual Control System Component problem. Control System versus other components including the Engine or Transmission. © 2011 Yanmar Marine International • Rev. 2.0 15:2 Yanmar Electronic Control Systems Technical Manual