15 Troubleshooting When Items in Table 1 indicate a system power problem, use this table for additional information. If a power problem exists, it needs to be located and corrected before proceeding with any communication or individual item issues. See the “Power Problems Table” on page 15:12. © 2011 Yanmar Marine International • Rev. 2.0 15:4 Yanmar Electronic Control Systems Technical Manual TABLE 2 - System Power Problems Problem Cause Reason/Solution Most or all units do not power ON. No system power. • Breaker or switch turned off. • Low or dead batteries. • Blown fuse or tripped breaker. • No CAN Bus power. An individual unit does not power on. No power to that unit.
• Unit switched off. • Tripped breaker or blown fuse. • Bad connection. No lights on Control Head. • No CAN Bus power. • Engine interface or actuator not connected or misconnected. • Press SELECT button on head. No flash of green LED, check for CAN Bus power. • Press SELECT button on head. If green LED flashes, head has power. Check communication to engine interface. Specific Alarm Messages for a product or module. • Out of spec condition. • May be a power or data issue. Check for possible details about message in this, the installation, and/ or engine manuals. BY or BY2 Unlimited stern drive actuator. No power. • Blown fuse, located at the actuator connector. • No CAN Bus power.
• Replace fuse. • Check CAN Bus power supply and acutator connections. i5601E Display does not turn on. • No CAN Bus power. • Contrast is set too low. Unit is on but display reads as blank • If CAN Bus power is present check for defective cable or replace unit. • See i5601E Section to increase contrast. • Round gauges do not move. • BY2 tachometer display is OFF. No CAN Bus power. Check CAN Bus power supply (see Table 5).