40 SEBU8598 Engine Operation Engaging the Driven Equipment Manual A manual regeneration is initiated by pressing the FORCE REGENERATION switch. A manual regeneration may be performed at a low idle speed or during normal engine operation. The soot loading must be between 15% and 116% for a manual regeneration to occur while the engine is at a low idle speed. The soot loading must be between 15% and 105% for a manual regeneration to occur at normal engine operating speed. The engine coolant temperature should be at least 40° C (104° F).
Illustration 35 g02117259 The DPF indicator lamp illuminates and the DIAGNOSTIC indicator lamp illuminates when the engine control module (ECM) determines that the amount of soot collected in the DPF has reached a level that requires a regeneration. Place the engine into a low idle state immediately. Initiate a manual regeneration. The engine power will be derated if the engine continues to operate. Disabled When the regeneration system is in disabled mode, automatic regeneration is not available.
Regeneration System Warning Indicators Illustration 36 g02117261 Illustration 34 g02117258 When the soot load reaches 116%, the DIAGNOSTIC indicator lamp illuminates, the DPF indicator lamp illuminates and the audible horn sounds. Not all applications have an audible horn. After 5 minutes of engine operation at 116% of soot load, the engine is automatically taken to the programmed low idle speed. A manual regeneration in the low speed region is then required. A complete regeneration will unlock the forced low idle speed. Cycling the engine START SWITCH KEY unlocks the forced low idle speed.
The DPF indicator lamp illuminates when the DPF soot load is greater than 80% A regeneration should be performed as soon as possible. Engine operation may not be allowing an automatic regeneration to occur. A manual regeneration should be performed as soon as possible. The DPF indicator lamp will turn off when DPF regeneration starts. After the engine operates at 116% of soot level for 10 minutes, all types of regeneration are locked out. A service regeneration through the CAT ETservice tool is the only form of regeneration allowed. Note: In some situations, the DPF indicator lamp may remain illuminated when the soot load is below 80%.
The illuminated DPF indicator lamp indicates that a complete regeneration has not been completed. A complete regeneration reduces the soot level to 0%. If the DPF indicator lamp remains illuminated, perform a regeneration without interruption until the soot level is 0%. A complete regeneration resets the DPF indicator lamp. If the engine continues to operate without a regeneration until a soot level of 140% is reached, the engine shuts down after 30 seconds. The engine may be restarted but will only run for 30 seconds at a time before shutting down. At this time, service level regeneration is locked out and the DPF must be replaced. i04038637 Engaging the Driven Equipment SMCS Code: 1000 1.
Operate the engine at one-half of the rated rpm, when possible.