Caterpillar — Caterpillar C15 and C18 Engine Operation and Maintenance Manual

64 SEBU8598 Maintenance Recommendations Compression Brake - Inspect/Adjust/Replace Two or More Belts 5. Tighten the jam nut to a torque of 200 ± 25 N·m (148 ± 18 lb ft) Table 9 (1) Belt with over 30 minutes of operation at a rated speed Belt Adjustment Repeat steps 1, 4, and 5 from the belt replacement procedure. i03965390 Compression Brake - Inspect/ Adjust/Replace SMCS Code: 1119-025; 1119-040; 1119-510 Illustration 47 g02478261 Belt tensioner Contact your Cat dealer for the proper procedure. (1) Adjustment bolt (2) 46 mm (1-13/16 inch) jamming locknut (jam nut) (A) 22 mm (0.87 inch) i04156977 Coolant (DEAC) - Change Inspection of the Belts SMCS Code:

1350-070; 1395-044 Clean the cooling system and flush the cooling system before the recommended maintenance interval if the following conditions exist: Inspect the fan drive belts for wear and for cracking. Replace the belts if the belts are not in good condition. Belt Replacement The engine overheats frequently. For applications that require multiple drive belts, replace the drive belts in matched sets. Replacing one drive belt of a matched set will cause the new drive belt to carry more load because the older drive belts are stretched. The additional load on the new drive belt could cause the new drive belt to fail. Foaming is observed.

The oil has entered the cooling system and the coolant is contaminated. The fuel has entered the cooling system and the coolant is contaminated. Use the following procedure to change the belts. NOTICE Use of commercially available cooling system cleaners may cause damage to cooling system com- ponents. Use only cooling system cleaners that are approved for Caterpillar engines. 1. Using a 46 mm (1-13/16 inch) wrench, loosen the jam nut (2). Note: See figure 47 , dimension (A). 2. Loosen the adjustment bolt (1). Note: Inspect the water pump and the water temperature regulator after the cooling system has been drained. 3. Remove the old belt and replace with a new belt.

Contact your Cat dealer for assistance in choosing and ordering new belts. 4. Tighten the adjustment bolt (1). Use a 144-0235 Belt Tension Gauge to ensure that belt is tensioned according to table 9 . Fan Drive Belt Adjustment Belt Tension (Initial) Belt Tension (Used)(1) 801 ± 44 N (180 ± 10 lb) 378 ± 44 N (85 ± 10 lb)