Leakage test of lock Leakage test of lock Pressurize the lock (p = 1 bar), close shut-off valve and remove air line. No noticeable pressure loss is allowed No noticeable pressure loss is allowed to occur within 10 sec. to occur within 10 sec. ц This operation is only necessary for hydraulic lock diferential (option). 7609AAX131 By rotating the input flange, roll crown wheel over the input pinion in both directions several times. Then remove the axle housing again and lift the differential out of the axle drive housing. Compare the obtained contact pattern.
In case of any contact patter n In case of any contact patter n deviation, a measuring error was deviation, a measuring error was made when determining the shim made when determining the shim (AX115, page 3-233), which must be (AX115, page 3-233), which must be corrected by all means. corrected by all means. 7609AAX132 After the contact pattern check insert the differential again into the axle drive housing. Load carrying device 5870 281 083 7609AAX133 3-238