Kaiyi — Kaiyi Power Train System Technical Manual

Some fault codes are not applied to this machine. 3-64 Fault code (Hex) Meaning of the fault code possible reason for fault detection Reaction of the TCU Possible steps to repair 76 O.C. at clutch K2 The measured resistance value of the valve is out of limit  Cable/connector is defective and has no contact to TCU Regulator has an internal defect TCU shifts to neutral OP mode : Limp home If failure at another clutch is pending TCU shifts to neutral OP mode : TCU shutdown  Check the cable from TCU to the gearbox  Check the connectors from gearbox to TCU  Check the regulator resistance*  Check internal wire harness of the gearbox * See page 3-74 77 S.C.

to battery voltage at clutch K3 The measured resistance value of the valve is out of limit, the voltage at K3 valve is too high Cable/connector is defective and has contact to battery voltage Cable/connector is defective and has contact to another regulator output of the TCU Regulator has an internal defect TCU shifts to neutral OP mode : Limp home If failure at another clutch is pending TCU shifts to neutral OP mode : TCU shutdown  Check the cable from TCU to the gearbox  Check the connectors from gearbox to TCU  Check the regulator resistance*  Check internal wire harness of the gearbox * See page 3-74 78 S.C.

to ground at clutch K3 The measured resistance value of the valve is out of limit, the voltage at K3 valve is too low Cable/connector is defective and has contact to vehicle ground Regulator has an internal defect TCU shifts to neutral OP mode : Limp home If failure at another clutch is pending TCU shifts to neutral OP mode : TCU shutdown  Check the cable from TCU to the gearbox  Check the connectors from gearbox to TCU  Check the regulator resistance*  Check internal wire harness of the gearbox * See page 3-74 79 O.C.

at clutch K3 The measured resistance value of the valve is out of limit Cable/connector is defective and has no contact to TCU Regulator has an internal defect TCU shifts to neutral OP mode : Limp home If failure at another clutch is pending TCU shifts to neutral OP mode : TCU shutdown  Check the cable from TCU to the gearbox  Check the connectors from gearbox to TCU  Check the regulator resistance*  Check internal wire harness of the gearbox * See page 3-74 7D S.C.

ground at engine derating device Cable is defective and is contacted to vehicle ground Engine derating device has an internal defect Connector pin is contacted to vehicle ground Engine derating will be on until TCU power down even if fault vanishes (Loose connection) OP mode : Normal  Check the cable from TCU to the engine derating device  Check the connectors from engine derating device to TCU  Check the resistance* of engine derating device  Not used * See page 3-74 7E S.C. battery voltage at engine derating device Cable/connector is defective and is contacted to battery voltage Engine derating device has an internal defect No reaction OP mode :

Normal  Check the cable from TCU to the engine derating device  Check the connectors from backup alarm device to TCU  Check the resistance* of backup alarm device * See page 3-74