Kaiyi — Kaiyi Power Train System Technical Manual

侍# Some fault codes are not applied to this machine. 3-66 Fault code (Hex) Meaning of the fault code possible reason for fault detection Reaction of the TCU Possible steps to repair 86 O.C. at clutch KV The measured resistance value of the valve is out of limit ÂCable/connector is defective and has contact to TCU ÂRegulator has an internal defect TCU shifts to neutral OP mode : Limp home If failure at another clutch is pending TCU shifts to neutral OP mode : TCU shutdown 余 Check the cable from TCU to the gearbox 余 Check the connectors from gearbox to TCU 余 Check the regulator resistance* 余 Check internal wire harness of the gearbox * See page 3-74 87 S.C.

to battery voltage at clutch KR The measured resistance value of the valve is out of limit, the voltage at KR valve is too high ÂCable/connector is defective and has contact to battery voltage ÂCable/connector is defective and has contact to another regulator output of the TCU ÂRegulator has an internal defect TCU shifts to neutral OP mode : Limp home If failure at another clutch is pending TCU shifts to neutral OP mode : TCU shutdown 余 Check the cable from TCU to the gearbox 余 Check the connectors from gearbox to TCU 余 Check the regulator resistance* 余 Check internal wire harness of the gearbox * See page 3-74 88 S.C.

to ground at clutch KR The measured resistance value of the valve is out of limit, the voltage at KR valve is too low ÂCable/connector is defective and has contact to vehicle ground ÂRegulator has an internal defect TCU shifts to neutral OP mode : Limp home If failure at another clutch is pending TCU shifts to neutral OP mode : TCU shutdown 余 Check the cable from TCU to the gearbox 余 Check the connectors from gearbox to TCU 余 Check the regulator resistance* 余 Check internal wire harness of the gearbox * See page 3-74 89 O.C.

at clutch KR The measured resistance value of the valve is out of limit ÂCable/connector is defective and has no contact to TCU ÂRegulator has an internal defect TCU shifts to neutral OP mode : Limp home If failure at another clutch is pending TCU shifts to neutral OP mode : TCU shutdown 余 Check the cable from TCU to the gearbox 余 Check the connectors from gearbox to TCU 余 Check the regulator resistance* 余 Check internal wire harness of the gearbox * See page 3-74 91 S.C. to ground at relay reverse warning alarm TCU detected a wrong voltage at the output pin, that looks like a S.C.

to vehicle ground ÂCable is defective and is contact to vehicle ground ÂBackup alarm device has an internal defect ÂConnector pin is contacted to vehicle ground Backup alarm will be on until TCU power down even if fault vanishes(Loose connection) OP mode : Normal 余 Check the cable from TCU to the backup alarm device 余 Check the connectors from backup alarm device to TCU 余 Check the resistance* of backup alarm device * See page 3-74 92 S.C. to battery voltage at relay reverse warning alarm TCU detected a wrong voltage at the output pin, that looks like a S.C.

to battery voltage ÂCable is defective and is contacted to battery voltage ÂBackup alarm device has an internal defect ÂConnector pin is contacted to battery voltage No reaction OP mode : Normal 余 Check the cable from TCU to the backup alarm device 余 Check the connectors from backup alarm device to TCU 余 Check the resistance* of backup alarm device * See page 3-74