Kaiyi — Kaiyi Power Train System Technical Manual

侍# Some fault codes are not applied to this machine. 3-67 Fault code (Hex) Meaning of the fault code possible reason for fault detection Reaction of the TCU Possible steps to repair 93 O.C. at relay reverse warning alarm TCU detected a wrong voltage at the output pin, that looks like a O.C. for this output pin ÂCable is defective and has no connection to TCU ÂBackup alarm device has an internal defect ÂConnector has no connection to TCU No reaction OP mode : Normal 余 Check the cable from TCU to the backup alarm device 余 Check the connectors from backup alarm device to TCU 余 Check the resistance* of backup alarm device * See page 3-74 94 S.C.

to ground at relay starter interlock TCU detected a wrong voltage at the output pin, that looks like a S.C. to vehicle ground ÂCable is defective and is connection to vehicle ground ÂStarter interlock relay has an internal defect ÂConnector pin is contacted to vehicle ground No reaction OP mode : Normal 余 Check the cable from TCU to the stater interlock relay 余 Check the connectors from starter interlock relay to TCU 余 Check the resistance* of starter interlock relay * See page 3-74 95 S.C. to battery voltage at relay starter interlock TCU detected a wrong voltage at the output pin, that looks like a S.C.

to battery voltage ÂCable is defective and has no connection to battery voltage ÂStarter interlock relay has an internal defect ÂConnector pin is contacted to battery voltage No reaction OP mode : Normal 余 Check the cable from TCU to the starter interlock relay 余 Check the connectors from starter interlock relay to TCU 余 Check the resistance* of starter interlock relay * See page 3-74 96 O.C. at relay starter interlock TCU detected a wrong voltage at the output pin, that looks like a O.C. for this output pin ÂCable is defective and has no connection to TCU ÂStarter interlock relay has an internal defect ÂConnector has no connection to TCU No reaction OP mode :

Normal 余 Check the cable from TCU to the starter interlock relay 余 Check the connectors from starter interlock relay to TCU 余 Check the resistance* of starter interlock relay * See page 3-74 9A S.C. to ground at converter lock up clutch solenoid TCU detected a wrong voltage at the output pin, that looks like a S.C. to vehicle ground ÂCable is defective and is contacted to vehicle ground ÂConverter clutch solenoid has an internal defect ÂConnector pin is contacted to vehicle ground No reaction OP mode :

Normal 余 Check the cable from TCU to the converter clutch solenoid 余 Check the connectors from converter clutch solenoid to TCU 余 Check the resistance* of converter clutch solenoid * See page 3-74