Kaiyi — Kaiyi Power Train System Technical Manual

侍# Some fault codes are not applied to this machine. 3-68 Fault code (Hex) Meaning of the fault code possible reason for fault detection Reaction of the TCU Possible steps to repair 9B O.C. at converter lock up clutch solenoid TCU detected a wrong voltage at the output pin, that looks like a O.C. for this output pin ÂCable is defective and has no connection to TCU ÂConverter clutch solenoid has an internal defect ÂConnector has no connection to TCU Converter clutch always o p e n , r e t a r d e r n o t available OP mode :

Normal 余 Check the cable from TCU to the converter clutch solenoid 余 Check the connectors from converter clutch solenoid to TCU 余 Check the resistance* of converter clutch solenoid * See page 3-74 9C S.C. to battery voltage at converter lock up clutch solenoid TCU detected a wrong voltage at the output pin, that looks like a S.C. to battery voltage ÂCable is defective and has no contacted to battery voltage ÂConverter clutch solenoid has an internal defect ÂConnector pin is contacted to battery voltage No reaction OP mode :

Normal 余 Check the cable from TCU to the converter clutch solenoid 余 Check the connectors from converter clutch solenoid to TCU 余 Check the resistance* of converter clutch solenoid * See page 3-74 A1 S.C. to ground at difflock or axle connection solenoid TCU detected a wrong voltage at the output pin, that looks like a S.C. to vehicle ground ÂCable is defective and is contacted to vehicle ground ÂDifflock solenoid has an internal defect ÂConnector pin is contacted to vehicle ground No reaction OP mode : Normal 余 Check the cable from TCU to the difflock solenoid 余 Check the connectors from difflock solenoid to TCU 余 Check the resistance* of difflock solenoid * See page 3-74 A2 S.C.

to battery voltage at difflock or axle connection solenoid TCU detected a wrong voltage at the output pin, that looks like a S.C. to battery voltage ÂCable is defective and has no connection to battery voltage ÂDifflock solenoid has an internal defect ÂConnector pin is contacted to battery voltage No reaction OP mode : Normal 余 Check the cable from TCU to the difflock solenoid 余 Check the connectors from difflock solenoid to TCU 余 Check the resistance* of difflock solenoid * See page 3-74 A3 O.C. at difflock or axle connection solenoid TCU detected a wrong voltage at the output pin, that looks like a O.C.

for this output pin ÂCable is defective and has no connection to TCU ÂDifflock solenoid has an internal defect ÂConnector has no connection to TCU No reaction OP mode : Normal 余 Check the cable from TCU to the difflock solenoid 余 Check the connectors from difflock solenoid to TCU 余 Check the resistance* of difflock solenoid * See page 3-74