Kaiyi — Kaiyi Power Train System Technical Manual

侍# Some fault codes are not applied to this machine. 3-71 Fault code (Hex) Meaning of the fault code possible reason for fault detection Reaction of the TCU Possible steps to repair BB Slippage at converter lockup clutch TCU calculates a differential speed at closed converter lockup clutch. If this calculated value is out of range, TCU interprets this as slipping clutch ÂLow pressure at converter lockup clutch ÂLow main pressure ÂWrong signal at engine speed sensor ÂWrong signal at turbine speed sensor ÂWrong size of the sensor gap ÂClutch is defective No reaction OP mode :

Normal 余 Check pressure at converter lockup clutch 余 Check main pressure in the system 余 Check sensor gap at engine speed sensor 余 Check sensor gap at turbine speed sensor 余 Check signal at engine speed sensor 余 Check signal at turbine speed sensor 余 Replace clutch C0 Engine torque or engine power overload TCU calculates an engine torque or engine power above the defined thresholds OP mode : Normal C1 Transmission output torque overload TCU calculates an transmission output torque above the defined threshold OP mode : Normal C2 Transmission input torque overload TCU calculates an transmission input torque above the defined threshold programmable :

No reaction or shift to neutral OP mode : Normal C3 Overtemp converter output TCU measured a oil temperature at the converter output that is the allowed threshold No reaction OP mode : Normal 余 Cool down machine 余 Check oil level 余 Check temperature sensor C4 S.C. to ground at joystick status indicator TCU detected a wrong voltage at the output pin, that looks like a S.C. to vehicle ground ÂCable is defective and is contacted to vehicle ground ÂJoystick status indicator has an internal defect ÂConnector pin is contacted to vehicle ground No reaction OP mode :

Normal 余 Check the cable from TCU to joystick status indicator 余 Check the connectors from joystick status indicator to TCU 余 Check the resistance* of joystick status indicator * See page 3-74 C5 S.C. to battery voltage at joystick status indicator TCU detected a wrong voltage at the output pin, that looks like a S.C. to battery voltage ÂCable is defective and is contacted to battery voltage ÂJoystick status indicatorhas an internal defect ÂConnector pin is contacted to battery voltage No reaction OP mode :

Normal 余 Check the cable from TCU to joystick status indicator 余 Check the connectors from joystick status indicator to TCU 余 Check the resistance* of joystick status indicator * See page 3-74