侍# Some fault codes are not applied to this machine. 3-72 Fault code (Hex) Meaning of the fault code possible reason for fault detection Reaction of the TCU Possible steps to repair C6 O.C. at joystick status indicator TCU detected a wrong voltage at the output pin, that looks like a O.C. for this output pin ÂCable is defective and has no connection to TCU ÂJoystick status indicatorhas an internal defect ÂConnector pin has no connection to TCU No reaction OP mode : Normal 余 Check the cable from TCU to joystick status indicator 余 Check the connectors from joystick status indicator to TCU 余 Check the resistance* of joystick status indicator * See page 3-74 D1 S.C.
to battery voltage at power supply for sensors TCU measures more than 6V at the pin AU1 (5V sensor supply) See fault codes No.21 to 2C 余 Check cables and connectors to sensors, which are supplied from AU1 余 Check the power supply at the pin AU1(Should be appx. 5V) 余 Fault codes No.21 to No.2C may be reaction of this fault D2 S.C. to ground at power supply for sensors TCU measures less than 4V at the pin AU1 (5V sensor supply) See fault codes No.21 to 2C 余 Check cables and connectors to sensors, which are supplied from AU1 余 Check the power supply at the pin AU1(Should be appx.
5V) 余 Fault codes No.21 to No.2C may be reaction of this fault D3 Low voltage at battery Measured voltage at power supply is lower than 18V(24V device) Shift to neutral OP mode : TCU shutdown 余 Check power supply battery 余 Check cables from batteries to TCU 余 Check connectors from batteries to TCU D4 High voltage at battery Measured voltage at power supply is higher than 32.5V(24V device) Shift to neutral OP mode :
TCU shutdown 余 Check power supply battery 余 Check cables from batteries to TCU 余 Check connectors from batteries to TCU D5 Error at valve power supply VPS1 TCU switched on VPS1 and measured VPS1 is off or TCU switched off VPS1 and measured VPS1 is still on ÂCable or connectors are defect and are contacted to battery voltage ÂCable or connectors are defect and are contacted to vehicle ground ÂPermanent power supply KL30 missing ÂTCU has an internal defect Shift to neutral OP mode :
TCU shutdown 余 Check fuse 余 Check cables from gearbox to TCU 余 Check connectors from gearbox to TCU 余 Replace TCU D6 Error at valve power supply VPS2 TCU switched on VPS2 and measured VPS2 is off or TCU switched off VPS2 and measured VPS2 is still on ÂCable or connectors are defect and are contacted to battery voltage ÂCable or connectors are defect and are contacted to vehicle ground ÂPermanent power supply KL30 missing ÂTCU has an internal defect Shift to neutral OP mode : TCU shutdown 余 Check fuse 余 Check cables from gearbox to TCU 余 Check connectors from gearbox to TCU 余 Replace TCU