侍# Some fault codes are not applied to this machine. 3-73 Fault code (Hex) Meaning of the fault code possible reason for fault detection Reaction of the TCU Possible steps to repair E3 S.C. to battery voltage at display output TCU sends data to the display and measures always a high voltage level on the connector ÂCable or connectors are defective and are contacted to battery voltage ÂDisplay has an internal defect No reaction OP mode : Normal 余 Check the cable from TCU to the display 余 Check the connectors at the display 余 Change display E4 S.C.
to ground at display output TCU sends data to the display and measures always a high voltage level on the connector ÂCable or connectors are defective and are contacted to battery voltage ÂDisplay has an internal defect No reaction OP mode : Normal 余 Check the cable from TCU to the display 余 Check the connectors at the display 余 Change display E5 Communication failure on DeviceNet Shift to neutral OP mode : TCU shutdown 余 Check Omron master 余 Check wire of DeviceNet-Bus 余 Check cable to Omron master F1 General EEPROM fault TCU can't read non volatile memory ÂTCU is defective No reaction OP mode :
Normal 余 Replace TCU ö Often shown together with fault code F2 F2 Configuration lost TCU has lost the correct configuration and can't control the transmission ÂInterference during saving data on non volatile memory ÂTCU is brand new or from another vehicle Transmission stay neutral OP mode : TCU shutdown 余 Reprogram the correct configurat- ion for the vehicle (e.g. with cluster controller,...) F3 Application error Something of this application is wrong Transmission stay neutral OP mode :
TCU shutdown 余 Replace TCU ö This fault occurs only if an test engineer did something wrong in the application of the vehicle F5 Clutch failure AEB was not able to adjust clutch filling parameters ÂOne of the AEB-Values is out of limit Transmission stay neutral OP mode : TCU shutdown 余 Check clutch ö TCU shows also the affected clutch on the display F6 Clutch adjustment data lost TCU was not able to read correct clutch adjustment parameters ÂInterference during saving data on non volatile memory ÂTCU is brand new No reaction, Default values : 0 for AEB Offsets used OP mode :
Normal 余 Execute AEB and brake sensor calibration F7 Substitute clutch control ÂTransmission input torque wrong ÂEngine retarder torque wrong ÂSpeed signal (s) defective OP mode : Substitute clutch control 余 Check engine retarder torque 余 Check speed sensors