24. SERVICE PROCEDURE Turn radiator cap 0 slowly to remove it. 1. 2. Set a container to catch the coolant under drain valve 0 and drain plug 0. Open drain valve 0 at the bottom of the radiator and drain plug 0 on the side face of the cy- linder block to drain the water. 3. After draining the water, close drain valve 0 and drain plug 0, and fill with city water. 4. Open drain plug 0, run the engine at low idling, and flush water through the system for IO minutes. When doing this, adjust the speed of filling and draining the water so that the radiator is always full.
While flushing water through the system, watch carefully that the water inlet hose does not come out of the radia- tor water filler. 5. After flushing, stop the engine, open drain plug close it again after all the water has drained out. $9, then 6. After draining the water, clean with a flushing agent. We recommend you to use Komatsu genuine flushing agent KC. A CAUTION Flushing agent KC is a strong acid, so after flushing, add neutralizing agent KN to the container to neutralize the water, then drain the water. Do not put neutralizing agent KN inside the engine cool- ing water system.
The rust is ionized by flushing agent KC, but if neutralizing agent KN is added, sediment will be formed again, and this may accumulate inside the cooling system. (1) Use a clean polyethylene container, and dissolve one packet of flushing agent KC in 6 liters of water. If the container is large enough, it is possible to dis- solve all the necessary flushing agent at the same time. Add the KC solution to the radiator. Add water to the radiator to the specified water level. Tighten the radiator cap, and run the engine at idling at a midrange speed for one or two hours. Every 20 minutes, apply load to the engine. Stop the engine, then drain and add water in accord- ance with Steps 1 - 3.
(2) (3) (4) (5) 3-26