24. SERVICE PROCEDURE (6) Add water and open drain plug 0 at the same time, and run water to flush the system for about 30 minutes with the engine at a midrange speed. When doing this, be careful to adjust the amount of water supplied and drained to ensure that the radiator is always filled. After flushing for 30 minutes, take a sample and check the condition of the water in the cooling system. If the water is orange, continue flushing until the water becomes colorless and transparent.
When the drained water becomes colorless and trans- parent, collect 100 cc of the drained water in a con- tainer, add 5 cc of neutralizing agent KN (white pow- der), mix it well, and check that no blue-green or orange sediment is formed. If any blue-green or orange sediment is formed, con- tinue the flushing operation until this problem disap- pears. (7) (3) REMARK Flushing agent KC comes in packets of 500 g and neutra- lizing agent KN in packets of 250 g. (The specified density for the flushing agent KC is 35 gl!2, and for the neutralizing agent KN is 17.5 g/Q.) There is no problem in using commercially available flush- ing agents or neutralizing agent (when draining the water).
In this case, use the flushing agent or neutralizing agent in the way specified on the instruction sheet supplied with the agent. 3-27