Komatsu — 24.6 EVERY 500 HOURS SERVICE

24. SERVICE PROCEDURE Tighten up air bleeding plug 0. Push in the knob of feed pump 0 and tighten it. After replacing the filter cartridge, start the engine and check that there is no leakage of fuel from the filter seal surface. If there is any leakage of fuel, check the tighte- ning of the filter cartridge. Whenever there is leakage of fuel, follow Steps 1 and 2 to remove the filter cartridge, then check the packing surface for damage or foreign ma- terial. If any damage or foreign material is found in the packing, replace the packing with a new part, then repeat Steps 3 - 8 to install the filter cartridge.

Method of using automatic air bleed mechanism I A WARN’NG 1 When cranking the engine, confirm the safety around the engine, as the engine may start. It is possible to bleed the air from the fuel circuit simply by rotating the starting motor with the starting switch. Bleed the air as follows. After replacing the filter cartridge, check that the fuel con- trol lever is at the low idling position. Place the safety lever for the steering and directional lever to the lock position. Turn the starting switch key to the START position and ro- tate the starting motor for 15 - 20 seconds to crank the engine and bleed the air.

NOTICE When the engine has run out of fuel, carry out the same procedure and crank the engine for 15 - 20 seconds. Repeat this operation 2 - 3 times to bleed the air. Do not rotate the starting motor continuously for more than 20 seconds. Wait for 1 - 2 minutes before rotating again. The time taken to bleed the air is shorter when the fuel tank is full. 3-51