OPERATING SECTION 4 Page 17 INSTRUMENTS AND CONTROLS 41. AIR INTAKE MODE KNOB It is used to change mode of air intake: outside (fresh) or inside heated (recalculation) Fig. 4.7. Controls 28 - Parking Brake Knob (description above) 42 - Brake Pedal 43 - Transmission Neutral Lock Lever 44 - Transmission Gear Range Lever 45 - Transmission Direction Lever 46 - Steering Wheel 47 - Steering Wheel Height Adjustment Knob 48 - Auxiliary Equipment Lever 49 - Bucket Control Lever 50 - Boom Control Lever 51 - Accelerator Pedal 52 - Horn Button 54 - Hazard Light Switch With Control Light 55 - Directional Signal Switch 42. BRAKE PEDAL This pedal actuates the machine service brakes.
Depress the pedal, gradually increasing pressure, a desired braking action is achieved. The faster pressure is applied to the pedal, the stronger the braking WARNING! Do not “pump” the brakes. Repeatedly pressing and releasing the brake pedal will reduce the oil pressure in the system and result in reduced braking. As required, there is possibility of braking as described above with transmission connected and disconnected. Braking with transmission disconnected is with all transmission clutches released. Therefore full power of the engine can be used to operate the machine hydraulics .
Braking with transmission disconnected is more efficient because eliminates detrimental effect of rotating masses on braking. Selection of braking method is made with switch 22, Fig. 4.2. and 4.3. DRESSTA OM560C99/1E