DRIVING - Driver Assistance If the vehicle drops outside the speed range, PCC will accelerate the vehicle back to the minimum PCC speed. As the vehicle reaches flat ground after the hill, PCC will maintain the set-speed until the crest of the next hill. If the vehicle is equipped with Adaptive Cruise Control (ACC) and senses traffic slowing, it will overrule PCC and slow the vehicle. This event will cancel PCC only if the service brakes are required to slow the vehicle. If the service brakes are not used by ACC to maintain a safe following distance, PCC will remain engaged and resume automatically after the ACC event. When this happens, the vehicle will revert to standard cruise control.
This CC state will be standard cruise control which will maintain the same cruise speed that was selected for PCC. Once the system regains GPS signal and road data, PCC will resume. Fuel Economy Savings Not Achieved Certain conditions may cause the optimal vehicle speed, calculated by PCC, to be overruled. For example, PCC will be overruled in the following scenarios: Greenhouse Gas functionality Adaptive Cruise Control Following Event (if equipped) Adaptive Cruise Control Error State (if equipped) NOTE PCC Map coverage will include most interstate and state highways. If you happen to leave a supported roadway, the PCC will deactivate.
Standard cruise control will automatically step in to maintain the vehicle speed. 4 Disabling Predictive Cruise Control To disable PCC and enable standard cruise control, the truck must be taken to an authorized dealer. NOTE PCC was calibrated using a loaded ve- hicle. Your results may vary, depend- ing on your vehicle's configuration. Troubleshooting The display will show a message if it detects an error with the PCC system. PCC faults may result from the unavailability of map, slope, vehicle position, etc. To effectively diagnose and clear the fault codes, the truck must be taken to your local dealership.
Software Information The PCC ECU Software version and Map Data Version number can be found in the Menu Truck Information on page 77. . It may take up to two minutes for this information to be displayed after the truck has been keyed-on. PCC Interrupt There are three conditions that will automatically deactivate PCC: If there is no data for the current road. If the GPS signal is lost. If the PCC system detects a fault. PCC Controls PCC uses the same buttons as Cruise Control. See Cruise Control on page 142. Y53-6126-1A1 (01/21) 149